This article will be useful for you if you experiencing one of the following issues:
• Saffire product does not connect to the computer.
• You are having problems with installation.
• You are getting pops/clicks/fluttering distortions/audio drop-outs/sudden silence.
Use this article as a starting point to troubleshooting your issues. Follow through it one step at a time until your issue is resolved, as it may not be necessary to carry out all the pointers.
This article contains links to several other articles, so once you have been through another article and your issues are unresolved, return back here and follow the next step.
Check software/hardware setup.
- Check that you have the latest software/firmware
drivers from our website
- Check that the FireWire cable is connected properly.
- Try using the supplied power cable.
- Try using the other FireWire port found on the back of your Saffire product, and also try different ports (if you have more than one) on your computer.
- If you have any other FireWire devices connected, try disconnecting them, as they may be restricting the FireWire bandwidth too much if connectedon the same bus.
NB: You may have more than one FireWire port on your computer. Note that they may be connected to the same bus, even though they appear to be physically seperate. This will be the case if you have a FireWire card with multiple FireWire ports on (all ports on the card will be on the same bus), and is also often the case if you have multiple ports inbuilt on you system.
- Check the chipset and type of FireWire card. We recommend FireWire 400-only, non-combo (i.e. not with USB AND FireWire ports) cards with either a Texas Instruments or a VIA chipset, from a known brand manufacturer such as Belkin, Lacie or SIIG.
Other chipsets and models also work, but the above specs will give the best results. For more information see FireWire compatibility article
Windows specific points.
- Follow the tuning tips given in the article relevant to your system to set it up optimally for audio use.
XP tuning tips.
(Make sure you follow the link to the Microsoft website and download the Firewire patch).
Vista tuning tips.
- Saffire, Saffire LE, Saffire Pro 10/26 users:
Increase the FireWire buffer size on your FireWire card, found at C:/Program Files/Focusrite [Saffire product]/Driver/ASIOControlPanel.exe (where [Saffire product] is the name of your Saffire product). Its default setting is 2ms, but you may find that increasing it helps connectivity and will improve audio performance, at the cost of increasing latency
- Saffire Pro 40 and Liquid Saffire 56 users:
Increase the ASIO
buffer size in the Settings menu of the Saffire MixControl software. Also try increasing the Device Mode to a higher Safe Mode type.
- Adjust the PCI latency
timer values of your PCI devices. Instructions of how to do this can be found here
- Download and run the DPC latency
If after running this it flags up that your system is not suitable for audio use (you may also see high yellow and red bars which may indicate a conflict between devices), then contact Customer Support (link at bottom of page).
Mac specific points.
- Ensure you have installed the correct version of the AppleFWAudio driver. Instructions on how to check and if applicable, update this can be found here
Failing these pointers, contact Customer Support
detailing your system specifications and also all troubleshooting tips you have tried. If on a PC, screenshots of the PCI latency
tool and the DPC latency
checker will help speed the process of solving your issue.