Rednet .: Focusrite Answerbase

Problems streaming audio at 96kHz from Dante Virtual Soundcard
Currently, in order to Dante Virtual Soundcard to pass audio correctly a certain Dante Latency setting must be used in the Dante Virtual Soundcard settings. You must switch off Dante Virtual...
2013-04-26 Views: 113

I can't see metering in RedNet Control
If you find that you have no metering on the graphics in RedNet Control, then this is likely due to a FireWall on your system. You will need to add RedNet Control to the list of exceptions...
2013-04-25 Views: 91

Which network cables are suitable for use with Rednet?
A RedNet network requires a Gigabit network infrastructure. The following cable types are permitted: Cat 5e Cat 6 Both shielded and unshielded cables are suitable. As dictated by...
2011-01-12 Views: 1420

Which Ethernet Switches are suitable for use with Rednet?
Dante makes use of standard Voice over IP (VoIP) Quality of Service (QoS) switch features, to prioritize clock sync and audio traffic over other network traffic. VoIP QoS features are available in...
2011-01-12 Views: 1723

How can I connect a Rednet system to my computer?
There are two ways to connect a Rednet system to your computer: the Rednet PCIe card, or using Dante Virtual Soundcard (DVS). Rednet PCIe Card Connecting Rednet to a computer via the...
2011-01-12 Views: 2383

What is the maximum channel count of a Rednet system?
If using the Rednet PCIe card, the maximum channel count is 128 inputs x 128 outputs from 44.1kHz to 96kHz, and 64 inputs x 64 outputs at 192kHz. If using the Dante Virtual Soundcard (DVS), the...
2011-01-12 Views: 1732

What latency performance can be achieved with Rednet?
Using the Rednet PCIe card, it is possible to achieve a round trip latency figure of less than 3ms at all sample rates, assuming a DAW buffer size of 32 samples or less. The latency performance...
2011-01-12 Views: 1935

What is Dante?
Dante™ is a digital audio networking technology developed by Australian company Audinate, and it sits at the heart of all of our RedNet interfaces. Dante uses standard IP-based networking and...
2011-05-19 Views: 963

I get a No More Flows error in Dante Controller
This is commonly caused by people using Static IP Addresses. RedNet uses Bonjour in order to assign IP addresses to elements of the RedNet system automatically. This means that if using a...
2013-04-05 Views: 124

Rednet

Subcategories

Articles