Rednet 3 .: Focusrite Answerbase

Problems streaming audio at 96kHz from Dante Virtual Soundcard
Currently, in order to Dante Virtual Soundcard to pass audio correctly a certain Dante Latency setting must be used in the Dante Virtual Soundcard settings. You must switch off Dante Virtual...
2013-04-26 Views: 124

Audio connections on the Rednet 3
The Rednet 3 provides a maximum of 32 digital inputs and outputs using the following connections and protocols: - 32 channels of ADAT optical inputs and outputs (16 I/O at 192kHz) via 16 Toslink...
2011-03-17 Views: 1677

How can I synchronise my Rednet 3 with external digital devices?
The Rednet 3 can be used to synchronise your Rednet system clock to external digital audio devices, either via the clock signals embedded in the incoming digital audio streams (ADAT, AES, or...
2011-03-17 Views: 1471

Which network cables are suitable for use with Rednet?
A RedNet network requires a Gigabit network infrastructure. The following cable types are permitted: Cat 5e Cat 6 Both shielded and unshielded cables are suitable. As dictated by...
2013-04-25 Views: 63

I can't see metering in RedNet Control
If you find that you have no metering on the graphics in RedNet Control, then this is likely due to a FireWall on your system. You will need to add RedNet Control to the list of exceptions...
2013-04-25 Views: 73

I get a No More Flows error in Dante Controller
This is commonly caused by people using Static IP Addresses and trying to route between Dante Virtual Soundcard and . RedNet uses Bonjour in order to assign IP addresses to elements of the...
2013-04-25 Views: 70

Rednet 3

Articles