Back to Focusrite.com
Focusrite Answerbase
The Official Source for Focusrite Product Support and Information
English | German
Glossary Contact Us
Search  
Main Index .: Platinum Range .: TrakMaster

TrakMaster

This product is now discontinued.

Articles

article When recording with my Trak Master my receiving device shows a good signal level but the meter on the Trak Master barely registers. Is this right?
The Trak Master output LED meter measures in dBFS, where odBFS is the maximum permissable level before clipping. 0dBFS, on the Trak Master, is equal to +20dBu (the more common measurement of...

2005-08-05    Views: 4400   
article No sound output when using the MIC INPUT.
- Is the power switched on?- Is the LINE switch on the front panel switched out?- Are the INPUT and OUTPUT LEVELS set correctly?- For mics that require phantom power (ie condenser microphones),...

2005-08-03    Views: 6205   
article What is the 'Post EQ' button for on my TrakMaster?
The post EQ switch changes the signal routing in the unit so that after the pre amp the signal goes to the EQ first and then the compressor. By EQing the signal before it is compressed you can...

2005-08-05    Views: 4815   
article What do the 'tight' and 'punch' buttons do to the signal on the TrakMaster?
The 'tight' switch alters the ratio of the compressor from 2.5:1 to 6:1. When engaged the compressor will squash the signal more and give it less of a dynamic range than when switched out. For...

2005-08-05    Views: 3014   


.: Powered by Lore 1.6.3

Copyright 2008 Focusrite Audio Engineering Ltd. All Rights Reserved.